Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
The cost to diagnose the B1B0A MITSUBISHI code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
This Diagnostic Trouble Code (DTC) sets when the ORC detects a open or high resistance on the squib circuit for more than 2.5 seconds. This DTC transitions from active to stored when the ORC sees a recovery from the open or high resistance condition for greater than 2.5 seconds.
When powered, the Occupant Restraint Controller (ORC) sends a test current to the squibs to verify the integrity of the squib and wiring. These circuits are maintained in a floating configuration at the module (connected to neither power nor ground), as protection against inadvertent deployment. The use of the SRS Load Tool Adapter provides a test point as well as a method for opening the shorting bar connections within the harness connector. The ORC sends out a 40 mA diagnostic current on each squib voltage supply circuit at power up and every 500 ms thereafter while the ignition is on.
Need more information on how to fix the B1B0A MITSUBISHI code?
Get Access to Factory Service Manuals
Get the b1b0a mitsubishi code diagnosed by a professional: Find a repair shop in your area