Engine-Codes - Toyota - B1941 Toyota

B1941 Toyota Code - Open in Selectable Force Limiter Squib Right Circuit

- Code Popularity: 683 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B1941 Toyota?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Front Seat Outer Belt Assembly Right (RH) (Selectable Force Limiter Squib Right)
  • Front Seat Outer Belt Assembly Right harness is open or shorted
  • Front Seat Outer Belt Assembly Right circuit poor electrical connection
  • Faulty Center Airbag Sensor Assembly
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC B1941 Toyota?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B1941 Toyota Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B1941 Toyota code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Air Bag Warning Light ON

What Does the B1941 Toyota Code Mean?

The Selectable Force Limiter Squib Right (RH) Circuit consists of the Center Airbag Sensor Assembly and Front Seat Outer Belt Assembly Right (RH). This circuit instructs the Supplemental Restraint System (SRS) to deploy when the deployment conditions are met. The Diagnostic Trouble Code (DTC) is recorded when a malfunction is detected in the Selectable Force Limiter Squib Right Circuit.

B1941 Toyota Code - Open in Selectable Force Limiter Squib Right Circuit

Need more Information on the Code?

Need more information on how to fix the B1941 Toyota code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B1941 Toyota code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.