Engine-Codes - Generic - B1932

B1932 Code - Air Bag Driver Circuit Open

- Code Popularity: 21,505 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code B1932?

  • Faulty Driver Air Bag Module
  • Driver Air Bag Module harness is open or shorted
  • Driver Air Bag Module circuit poor electrical connection
  • Faulty Clockspring
  • Faulty Restraint Control Module (RCM)

|How to Fix the B1932 Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the Cost to Diagnose the Code B1932?

Labor: 1.0

The cost to diagnose the B1932 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your Car have Safety Recalls? → Check here

|What are Code B1932 Possible Symptoms?

  • Air Bag Warning Light ON

|What Does the B1932 Code Mean?

The Restraints Control Module (RCM) checks all of the Driver Air Bag Module Squib 1 circuits for faults. If the RCM detects an open or low resistance on the Driver Air Bag Module Squib 1 Circuit, it will store the Diagnostic Trouble Code (DTC) B1932 in memory and illuminate the air bag indicator.

B1932 Code - Air Bag Driver Circuit Open

|Need more Information on the B1932 Code?

Need more information on how to fix the B1932 code? Get Access to Factory Service Manuals

|Code B1932 Information for Specific Makes

|Need Help with the B1932 Code?

Get the B1932 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.