Engine-Codes - Generic - B1925

B1925 Code - Air Bag Passenger Circuit Short To Battery

- Code Popularity: 6,217 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

What are the Possible Causes of the Code B1925?

  • Faulty Air Bag Control Module
  • Air Bag Control Module harness is open or shorted
  • Air Bag Control Module circuit poor electrical connection

How to Fix the B1925 Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

What is the Cost to Diagnose the Code B1925?

Labor: 1.0

The cost to diagnose the B1925 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your Car have Safety Recalls? → Check here

What are Code B1925 Possible Symptoms?

  • Air Bag Warning Light ON

What Does the B1925 Code Mean?

The Air Bag Control Module monitors the Air Bag Passenger Circuit. The Air Bag Control Module sets the OBDII code when the Air Bag Passenger Circuit is not to factory specifications.

B1925 Code - Air Bag Passenger Circuit Short To Battery

Need more Information on the B1925 Code?

Need more information on how to fix the B1925 code? Get Access to Factory Service Manuals

Code B1925 Information for Specific Makes

Need Help with the B1925 Code?

Get the B1925 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.