What are the Possible Causes of the Code B1847 Toyota?
Faulty Curtain Shield Airbag Assembly Left (LH) (Curtain Shield Squib Left 2nd Step)
Curtain Shield Airbag Assembly Left harness is open or shorted
Curtain Shield Airbag Assembly Left circuit poor electrical connection
Faulty Center Airbag Sensor Assembly
How to Fix the B1847 Toyota Code?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the Cost to Diagnose the Code B1847 Toyota?
The cost to diagnose the B1847 Toyota code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The Curtain Shield Squib Left (LF) 2nd Step Circuit consists of the Center Airbag Sensor Assembly and the Curtain Shield Airbag Assembly Left (LH). The circuit instructs the Supplemental Restraint System (SRS) to deploy when deployment conditions are met. The Diagnostic Trouble Code (DTC) is stored when a malfunction is detected in the Curtain Shield Squib Left 2nd Step Circuit.
B1847 Toyota Code - Short To Ground In Curtain Shield Squib Left 2nd Step Circuit
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.