B1642 2016 Toyota RAV4 Code - Lost Communication With Side Satellite Sensor Bus Right
Quick Answer
The B1642 diagnostic trouble code for a 2016 Toyota RAV4 indicates that there is a communication issue with the Side Satellite Sensor Bus on the right side of the vehicle. Common causes include Faulty side satellite sensor on the right side, Wiring issues or damage to the communication lines, Faulty airbag control module. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- B1642 2016 Toyota RAV4 indicates Lost Communication With Side Satellite Sensor Bus Right.
- Common causes
- Common causes include Faulty side satellite sensor on the right side, Wiring issues or damage to the communication lines, Faulty airbag control module.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
Code B1642 2016 Toyota RAV4 Description
The B1642 diagnostic trouble code for a 2016 Toyota RAV4 indicates that there is a communication issue with the Side Satellite Sensor Bus on the right side of the vehicle. The side satellite sensors are essential components of the vehicle's safety system, specifically in relation to the airbag deployment and collision detection systems. These sensors are responsible for detecting impacts and communicating this information to the vehicle's airbag control module, which then determines if airbag deployment is necessary to protect the occupants in the event of a crash.
Common Causes of B1642 2016 Toyota RAV4
- Faulty side satellite sensor on the right side
- Wiring issues or damage to the communication lines
- Faulty airbag control module
- Corrosion or poor connections in the sensor circuit
- Electronic control unit (ECU) software issues
Symptoms of B1642 2016 Toyota RAV4
- Airbag warning light illuminated on the dashboard
- Airbag system not functioning properly
- Stability control system error messages
- Pre-collision system malfunction
- Loss of communication with other safety systems
How to Fix B1642 2016 Toyota RAV4
- Begin by conducting a thorough diagnostic scan to retrieve the specific fault codes and pinpoint the exact cause of the communication issue.
- Inspect the wiring harness and connections related to the side satellite sensor bus on the right side for any damage, corrosion, or loose connections. Repair or replace any faulty wiring as needed.
- Test the side satellite sensor on the right side to determine if it is functioning correctly. Replace the sensor if it is found to be faulty.
- Check the airbag control module for any malfunctions or software issues. Update the software if necessary or replace the module if it is defective.
- Clear the fault codes from the vehicle's system and perform a test drive to ensure that the communication issue has been resolved and that the safety systems are functioning correctly.
Cost to Fix B1642 2016 Toyota RAV4
The cost of repairing a lost communication issue with the side satellite sensor bus on a 2016 Toyota RAV4 can vary depending on the exact cause of the problem and the extent of the repairs needed. In general, the cost of parts for this repair can range from $200 to $600, while labor costs can range from $100 to $300, depending on the shop's hourly rates and the time required for the repair.
Need more information about the B1642 2016 Toyota RAV4 code?
Need more information on how to fix the B1642 2016 Toyota RAV4 code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the B1642 2016 Toyota RAV4 code diagnosed by a professional: Find a repair shop in your area
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
Frequently Asked Questions about B1642 2016 Toyota RAV4 Code
1. What are the common symptoms of OBDII code B1642 in a 2016 Toyota RAV4?
- Common symptoms include the airbag warning light illuminating on the dashboard, loss of communication with the side satellite sensor on the right side, and potential issues with the airbag system.
2. What could cause the OBDII code B1642 "Lost Communication With Side Satellite Sensor Bus Right" in a 2016 Toyota RAV4?
- Possible causes may include a faulty side satellite sensor on the right side, damaged wiring or connectors, a malfunctioning airbag control module, or a communication error within the vehicle's network.
3. How can I diagnose the OBDII code B1642 in my 2016 Toyota RAV4?
- Diagnosing this code typically involves using a professional OBDII scanner to retrieve the specific fault codes, inspecting the side satellite sensor and related components for damage, and checking the wiring connections for any issues.
4. Is it safe to drive my 2016 Toyota RAV4 with the OBDII code B1642 present?
- It is not recommended to drive the vehicle with this code present, as it indicates a potential issue with the airbag system. It is advised to address the problem promptly to ensure the safety features are functioning correctly.
5. Can I repair the OBDII code B1642 in my 2016 Toyota RAV4 myself?
- While some basic inspections like checking connections and fuses can be done by DIY enthusiasts, diagnosing and repairing complex airbag system issues should be left to professional technicians with the proper tools and expertise.
6. How much does it typically cost to repair the OBDII code B1642 in a 2016 Toyota RAV4?
- The cost of repair can vary depending on the specific cause of the code. It may range from a few hundred to a few thousand dollars, considering parts and labor expenses.
7. Are there any recalls or service bulletins related to the OBDII code B1642 in a 2016 Toyota RAV4?
- It's advisable to check with Toyota dealerships or their official website to see if there are any recalls or service bulletins related to this specific OBDII code for your vehicle.
8. What are the potential risks of ignoring the OBDII code B1642 in a 2016 Toyota RAV4?
- Ignoring this code could pose a risk in the event of a collision, as the airbag system may not deploy properly or at all. It's crucial to address any airbag-related issues promptly to ensure occupant safety.
9. How long does it take to repair the OBDII code B1642 in a 2016 Toyota RAV4?
- The repair time can vary based on the exact cause of the code and the availability of parts. It could take a few hours to a day or more to diagnose and fix the issue correctly.
10. Can resetting the OBDII code B1642 in a 2016 Toyota RAV4 make it go away permanently?
- Resetting the code may temporarily clear the warning light, but if the underlying issue causing the code is not addressed, it is likely to reappear. It's essential to diagnose and fix the root cause of the problem.
Discuss the causes and fixes for B1642 2016 Toyota RAV4 OBDII Code
Code B1642 2016 Toyota RAV4 comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.