Engine-Codes -
Lexus -
B1608 LEXUS
B1608 LEXUS - Front Satellite Sensor Bus Left Initialization Incomplete
Table of contents
B1608 LEXUS Possible Causes
- Faulty Front Airbag Sensor Left
- Front Airbag Sensor Left harness is open or shorted
- Front Airbag Sensor Left circuit poor electrical connection
- Faulty Center Airbag Sensor Assembly
How is the B1608 LEXUS code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.What is the cost to diagnose the B1608 LEXUS code
Labor: 1.0
The cost to diagnose the B1608 LEXUS code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Possible Symptoms
- Air Bag Warning Light ON
B1608 LEXUS Meaning
The Front Airbag Sensor Left consists of parts including the diagnostic circuit and the frontal deceleration sensor. When the Center Airbag Sensor Assembly receives signals from the Frontal Deceleration Sensor, it determines whether or not the SRS should be activated. The Diagnostic Trouble Code (DTC) is set when a malfunction is detected in the Front Airbag Sensor Left circuit.More Information
Need more information on how to fix the B1608 LEXUS code?Get Access to Factory Service Manuals
Need more help?
Get the B1608 Lexus code diagnosed by a professional: Find a repair shop in your areaPrecautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.