Engine-Codes - Buick - B153F BUICK

B153F BUICK Code - Liftgate Object Sensor Malfunction

- Code Popularity: 547 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the B153F BUICK Code?

  • Faulty Liftgate Object Sensors
  • Liftgate Object Sensors harness is open or shorted
  • Liftgate Object Sensors circuit poor electrical connection
  • Faulty Liftgate Control Module

|How to Fix the B153F BUICK Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|B153F BUICK code tech notes

B153F 02 Liftgate Object Sensor Signal Circuit Short to Ground
B153F 03 Liftgate Object Sensor Signal Circuit Voltage Below Threshold
B153F 05 Liftgate Object Sensor Signal Circuit Short to Battery or Open
B153F 07 Liftgate Object Sensor Signal Circuit Voltage Above Threshold

|What is the cost to diagnose the B153F BUICK code?

Labor: 1.0

The cost to diagnose the B153F BUICK code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are B153F BUICK code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the B153F BUICK Code Mean?

The liftgate object sensors are pressure sensitive touch tapes located on either side of the upper inside edge of the liftgate panel. The two liftgate object sensors are placed in series between the liftgate object sensor signal circuit and the liftgate object low reference circuit. Each object sensor has a resistor as well as a switch. The resistors enable the liftgate control module to perform diagnostic functions on the circuits. When both liftgate object sensors are not pressed, the 5 volt reference voltage supplied by the liftgate control module passes through the resistors and the liftgate control module detects approximately 3.3 volts. Pressing a liftgate object sensor will cause the voltage to drop to approximately to 2.5 volts indicating an obstruction is present. If the liftgate is in the open position, the liftgate control module will prohibit liftgate movement. If the obstruction occurs during the power close function, the liftgate control module will command the liftgate to reverse direction.

Liftgate Object Sensor Malfunction

|Need more information with the B153F BUICK code?

Need more information on how to fix the B153F BUICK code?
Get Access to Factory Service Manuals

|Need help with a B153F BUICK code?

Get the b153f buick code diagnosed by a professional: Find a repair shop in your area