Engine-Codes - Ford - B1507 Ford

B1507 Ford Code - Flash To Pass Switch Circuit Failure

- Code Popularity: 829 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B1507 Ford?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Headlamp Switch
  • Headlamp Switch harness is open or shorted
  • Headlamp Switch circuit poor electrical connection
  • Faulty Smart Junction Box (SJB)
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC B1507 Ford?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B1507 Ford Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B1507 Ford code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the B1507 Ford Code Mean?

The Smart Junction Box (SJB) sends reference signals to the headlamp switch through circuits. When the headlamp switch is placed in the HEADLAMPS ON position, the voltage signal is routed to ground through the circuit. If the SJB detects a fault with the headlamp switch inputs, the SJB turns the exterior lamps on by default. When the SJB detects the headlamp switch in the HEADLAMPS ON position and the multifunction switch in the LOW BEAM position, the SJB sends voltage through circuits to the low beam headlamps. When the SJB detects the headlamp switch in the HEADLAMPS ON position and the multifunction switch in the HIGH BEAM position, the SJB sends voltage through circuits to the high beam headlamps. The SJB sends a reference signal to the multifunction switch through circuits CLF27 (GN/BN) and CLF17 (WH/OG). When the multifunction switch is placed in the FLASH-TO-PASS or HIGH BEAM position, the voltage signal is routed to ground. When the SJB detects a request for the flash-to-pass, the SJB sends voltage to the high beam headlamps. The OBDII codes when the SJB detects a short to ground from the flash-to-pass input circuit.

B1507 Ford Code - Flash To Pass Switch Circuit Failure

Need more Information on the Code?

Need more information on how to fix the B1507 Ford code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B1507 Ford code diagnosed by a professional: Find a repair shop in your area