B14F4 FORD - High Side Driver 5

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

B14F4 FORD Possible Causes

  • Faulty Upfitter Interface Module
  • Upfitter Interface Module harness is open or shorted
  • Upfitter Interface Module circuit poor electrical connection

First diagnose B14F4 FORD code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

B14F4 FORD Tech Notes

B14F4:11 High Side Driver 5 Short To Ground
B14F4:12 High Side Driver 5 Short To battery
B14F4:13 High Side Driver 5 Open Circuit

Cost of diagnosing the B14F4 FORD code

    Labor: 1.0

    The cost of diagnosing the B14F4 FORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

B14F4 FORD Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

B14F4 FORD Meaning

The Upfitter Interface Module utilizes a Field Effect Transistor (FET) protective circuit strategy to protect the low and high side driver output circuits. Output loads (current levels) are monitored for excessive current (which is typically caused by a short circuit to ground) and are shut down (turns off the voltage or ground provided by the module) when a fault is detected.
A short to battery voltage occurring on either a low or high side driver output circuit may also result in a temporarily loss of operation in the output circuit (no voltage or ground will be applied to the output circuit) to protect the module against a potential over temperature condition.
A Field Effect Transistor (FET) is a type of transistor that the module uses to control and monitor current flow on module output circuits. The Field Effect Transistor (FET) protection strategy prevents damage from occurring to the module.
Whenever a FET is turned off because of a fault condition a Diagnostic Trouble Code (DTC) is set in the module which corresponds to the specific fault observed. The module resets the Field Effect Transistor (FET) protection and allows the circuit to function when the fault is corrected or the ignition is cycled off and then back on. The ignition should always be cycled from off to on after a fault is corrected to ensure that FET protection is reset.
OBDII Code B14F4 FORD - High Side Driver 5 - Engine-Codes.com

B14F4 FORD More Information

Need more information on how to fix the B14F4 FORD code?
Get Access to Factory Service Manuals

Related Information