Engine-Codes - Hyundai - B1496 HYUNDAI

B1496 HYUNDAI - Passenger Occupant Classification System Not Calibration

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What is this?
Table of contents

B1496 HYUNDAI Possible Causes

  • Faulty Occupant Classification (OC) Module
  • Occupant Classification (OC) Module harness is open or shorted
  • Occupant Classification (OC) Module circuit poor electrical connection

How is the B1496 HYUNDAI code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

What is the cost to diagnose the B1496 HYUNDAI code

Labor: 1.0

The cost to diagnose the B1496 HYUNDAI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Possible Symptoms

  • Air Bag Warning Light ON

B1496 HYUNDAI Meaning

The Passenger Occupant Classification System consists of the Supplemental Restraints System Control Module (SRSCM) and Occupant Classification (OC) Module. The Diagnostic Trouble Code (DTC) is recorded when OC system not calibration is detected in the OC module circuit.

More Information

Need more information on how to fix the B1496 HYUNDAI code?
Get Access to Factory Service Manuals

Need more help?

Get the B1496 Hyundai code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.