B140D:11 Second Row Passenger Side Seatbelt Sensor Circuit Short to Ground
B140D:12 Second Row Passenger Side Seatbelt Sensor Circuit Short to Battery
B140D:13 Second Row Passenger Side Seatbelt Sensor Circuit Open
B140D:1D Second Row Passenger Side Seatbelt Sensor Circuit Current Out of Range
⚠ Does your Lincoln have Safety Recalls? → Check here
How to Fix the DTC B140D Lincoln?
Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
Search for B140D Lincoln Questions and Answers: Search here →
What is the Cost to Diagnose the Code?
Labor: 1.0
The cost to diagnose the B140D Lincoln code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
What are Code Possible Symptoms?
Air Bag Warning Light ON
What Does the B140D Lincoln Code Mean?
The Restraint Control Module (RCM) continuously monitors the second row right safety belt buckle switch circuits for the following faults: Open circuit, Short to voltage, Short to ground, Current out of range, Faulted second row right safety belt buckle switch. If a fault is detected, the RCM stores DTC B140D in memory and sends a message to the IPC to illuminate the airbag warning indicator.
B140D Lincoln Code - Second Row Passenger Side Seatbelt Sensor Circuit
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.