Engine-Codes - Infiniti - B1347 INFINITI

B1347 INFINITI - Front Door Satellite Sensor Left Communication Error

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What is this?
Table of contents

B1347 INFINITI Possible Causes

  • Faulty Door Satellite Sensor Left
  • Door Satellite Sensor Left harness is open or shorted
  • Door Satellite Sensor Left circuit poor electrical connection
  • Faulty Air Bag Sensor Unit (Air Bag Control Module)

How is the B1347 INFINITI code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

What is the cost to diagnose the B1347 INFINITI code

Labor: 1.0

The cost to diagnose the B1347 INFINITI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Possible Symptoms

  • Air Bag Warning Light ON

B1347 INFINITI Meaning

The Door Satellite Sensor Left (Coupe) or Front Door Satellite Sensor Left (Sedan) is wired to the air bag diagnosis sensor unit. The Air Bag Sensor Unit (Air Bag Control Module) will monitor the Door Satellite Sensor Left (Coupe) or Front Door Satellite Sensor Left (Sedan) for internal failures and it's circuits for communication errors.

More Information

Need more information on how to fix the B1347 INFINITI code?
Get Access to Factory Service Manuals

Need more help?

Get the B1347 Infiniti code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.