Engine-Codes
 
OBDII Code List
 
B1343 CHEVROLET

B1343 CHEVROLET - Recirculation Actuator

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

B1343 CHEVROLET Possible Causes

  • Faulty Recirculation Actuator
  • Recirculation Actuator harness is open or shorted
  • Recirculation Actuator circuit poor electrical connection
  • Faulty Instrument Panel Module (IPM)

First diagnose B1343 CHEVROLET code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

Cost of diagnosing the B1343 CHEVROLET code

    Labor: 1.0

    The cost of diagnosing the B1343 CHEVROLET code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

B1343 CHEVROLET Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

B1343 CHEVROLET Meaning

The Instrument Panel Module (IPM) controls the HVAC door actuators to regulate the airflow through the Heating, Ventilation, and Air Conditioning (HVAC) system. Each actuator is a 5-wire bi-directional electric motor that incorporates a feedback potentiometer. Ignition 3 voltage, low reference, control, 5-volt reference and position signal circuits enable the actuator to operate. The control circuit uses either a 0, 2.5, or 5-volt signal to command the actuator movement. When the actuator is at rest, the control circuit value is 2.5 volts. A 0 or 5-volt control signal commands the actuator movement in opposite directions. When the actuator shaft rotates, the potentiometer's adjustable contact changes the door position signal between 0-5 volts. The IPM converts the voltage values to count values where one volt is approximately equal to 51 counts. The IPM uses a range of 0-255 counts to index the actuator position. The door position signal voltage is converted to a 0-255 count range. When the module sets a commanded, or targeted value, the control signal is changed to either 0 or 5 volts depending upon the direction that the actuator needs to rotate to reach the commanded value. As the actuator shaft rotates the changing position signal is sent to the module. Once the position signal and the commanded value are the same, the module changes the control signal to 2.5 volts.
OBDII Code B1343 CHEVROLET - Recirculation Actuator - Engine-Codes.com

B1343 CHEVROLET More Information

Need more information on how to fix the B1343 CHEVROLET code?
Get Access to Factory Service Manuals

Related Information