B1324 HYUNDAI - Passenger Occupant Classification System Communication Error
B1324 HYUNDAI Possible Causes
- Faulty Occupant Classification (OC) Module
- Occupant Classification Module harness is open or shorted
- Occupant Classification Module circuit poor electrical connection
- Faulty Supplemental Restraint System Control Module (SRSCM)
First diagnose B1324 HYUNDAI code
-
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
Cost of diagnosing the B1324 HYUNDAI code
Labor: 1.0
The cost of diagnosing the B1324 HYUNDAI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.B1324 HYUNDAI Possible Symptoms
- Air Bag Warning Light ON
B1324 HYUNDAI Meaning
The Passenger Occupant Classification (OC) System consists of the Supplemental Restraint System Control Module (SRSCM) and the OC Module. The Diagnostic Trouble Code (DTC) is recorded when a defect or communication error of the OC module is detected in the OC module circuit.
B1324 HYUNDAI More Information
Need more information on how to fix the B1324 HYUNDAI code?Get Access to Factory Service Manuals
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.