Engine-Codes - Jeep - B1297 Jeep

B1297 Jeep Code - Park Assist Sensor 10

- Code Popularity: 3,510 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B1297 Jeep?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Park Assist Sensor 10
  • Park Assist Sensor 10 harness is open or shorted
  • Park Assist Sensor 10 circuit poor electrical connection
  • Faulty Park Assist Module

Code Tech Notes

B1297-11 PTS SENSOR 10 CIRCUIT SHORT TO GROUND
B1297-12 PTS SENSOR 10 CIRCUIT SHORT TO BATTERY
B1297-25 PTS SENSOR 10 SIGNAL SHAPE / WAVEFORM FAILURE
B1297-92 PTS SENSOR 10 PERFORMANCE OR INCORRECT OPERATION

⚠ Does your Jeep have Safety Recalls? → Check here

How to Fix the DTC B1297 Jeep?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B1297 Jeep Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B1297 Jeep code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the B1297 Jeep Code Mean?

The Park Assist Sensors (PTS) are ultrasonic transceivers that are completely controlled by the Park Assist Module. The sensors transmit and receive ultrasonic signals. Each sensor has a voltage, signal, and return the circuit to the module. The sensors communicate with the Park Assist Module using a dedicated serial bus communication circuit. The Park Assist Module monitors the PTS Sensor when the vehicle in reverse and during the self-test while the vehicle is in drive between 18 km/h (11 mph) and 40 km/h (25 mph). The Park Assist Module sets the OBDII code when the Park Assist Sensor Signal circuit is not to factory specifications.

B1297 Jeep Code - Park Assist Sensor 10

Need more Information on the Code?

Need more information on how to fix the B1297 Jeep code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B1297 Jeep code diagnosed by a professional: Find a repair shop in your area