Engine-Codes - Buick - B125A Buick

B125A Buick Code - Antenna Signal Circuit

- Code Popularity: 1,193 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B125A Buick?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Radio Unit
  • Faulty Coax Cable
  • Faulty Cellular Phone, Navigation, and Digital Radio Antenna

Code Tech Notes

B125A:04 Antenna Signal Circuit Short to Battery
B125A:02 Antenna Signal Circuit Short to Ground
B125A:04 Antenna Signal Circuit Open

Poor AM and FM radio reception may be due to multiple influences, some of which may not be vehicle related. Areas that have high RF traffic or block the signal path may cause a degradation in radio reception. Radio reception may also be influenced by items within the vehicle, but not part of the radio system. Such examples are aftermarket electrical accessories or other items which may generate noise in the vehicle's electrical system. Aftermarket window tinting, especially when there is metallic in the film, may reduce radio reception.
AM reception is highly dependent on the antenna amplifier receiving battery voltage from the radio and being properly grounded. The antenna base has a built-in antenna amplifier that boosts both AM and FM reception. When the antenna amplifier does not receive power, AM stations may not be received, and FM reception will be limited. If the antenna base is not properly grounded, excessive interference in the signal may occur or reception may be limited.

⚠ Does your Buick have Safety Recalls? → Check here

How to Fix the DTC B125A Buick?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B125A Buick Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B125A Buick code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the B125A Buick Code Mean?

The digital radio receiver, located inside the radio, receives digital radio information from the digital radio antenna located on the outside of the vehicle. The digital radio receiver is connected to the digital radio antenna via a shielded coax cable. The digital radio antenna contains an amplifier that is powered by the radio through the coax cable. The Diagnostic Trouble Code (DTC) will be set when the radio detects a circuit fault in the digital radio antenna.

B125A Buick Code - Antenna Signal Circuit

Need more Information on the Code?

Need more information on how to fix the B125A Buick code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B125A Buick code diagnosed by a professional: Find a repair shop in your area