Engine-Codes - Lincoln - B1213 LINCOLN

B1213 LINCOLN Code - Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit

- Code Popularity: 1,231 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the B1213 LINCOLN Code?

  • Faulty Passenger Seatbelt Buckle Pretensioner
  • Passenger Seatbelt Buckle Pretensioner harness is open or shorted
  • Passenger Seatbelt Buckle Pretensioner circuit poor electrical connection
  • Faulty Restraints Control Module (RCM)

|How to Fix the B1213 LINCOLN Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|B1213 LINCOLN code tech notes

B1213:11 Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit Short to Ground
B1213:12 Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit Short to Battery
B1213:13 Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit Open
B1213:1A Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit Resistance Below Threshold

|What is the cost to diagnose the B1213 LINCOLN code?

Labor: 1.0

The cost to diagnose the B1213 LINCOLN code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are B1213 LINCOLN code possible symptoms?

  • Air Bag Warning Light ON

|What Does the B1213 LINCOLN Code Mean?

The Restraints Control Module (RCM) analyzes the deployment loop resistance to determine if a fault exists. The value displayed in the PID is the deployment loop resistance measured by the RCM. If the value displayed is lower or higher than the desired range, the RCM can set a Diagnostic Trouble Code (DTC). As the deployment loop resistance drifts farther outside the desired range, the chance for a DTC increases. Small variations in resistance can occur due to the effect of road vibrations on terminal fit. Crimps and terminals can be affected by stress and harness movement and can cause an increase in resistance due to wire strain. These variables can result in an intermittent fault. For this reason, the test requires the PID value to be within the desired range before the fault is considered repaired, regardless if the module is reporting an on-demand DTC at the time of diagnosis. Following this direction helps make sure that minor changes in resistance do not create a repeat concern.

Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit

|Need more information with the B1213 LINCOLN code?

Need more information on how to fix the B1213 LINCOLN code?
Get Access to Factory Service Manuals

|Need help with a B1213 LINCOLN code?

Get the B1213 Lincoln code diagnosed by a professional: Find a repair shop in your area