B11CD CHRYSLER - Main/Left Temperature Door Travel Too Large
B11CD CHRYSLER Possible Causes
- Driver Blend Door Binding
- Faulty Driver Blend Door Actuator
- Driver Blend Door Actuator harness is open or shorted
- Driver Blend Door Actuator circuit poor electrical connection
- Faulty A/C Heater Module
How is the B11CD CHRYSLER code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the B11CD CHRYSLER code
Labor: 1.0The cost to diagnose the B11CD CHRYSLER code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
B11CD CHRYSLER MeaningAfter the initial installation of the A/C Heater Module, the controller is calibrated to each individual blend/mode door actuator. These calibrations are stored as in the number of pulses it takes to move the door from one stop to another. The A/C Heater Module drives the Door Actuators by the use of Door Driver circuit and a Common Door Driver circuit and monitors all door actuator pulses to detect door movement in both directions. Most of the door actuators share a common door driver circuit but each door actuator has its own unique driver circuit. Due to shared circuitry, similar Diagnostic Trouble Codes (DTCs) can set at the same time for multiple actuators depending upon the type of circuit malfunction, its location, and the direction the actuator is moving when the malfunction is present. For further information.
More InformationNeed more information on how to fix the B11CD CHRYSLER code?
Get Access to Factory Service Manuals