|What are the Possible Causes of the B1183 INFINITI Code?
Faulty Left Front Seat Belt Buckle Pre-Tensioner
Left Front Seat Belt Buckle Pre-Tensioner harness is open or shorted
Left Front Seat Belt Buckle Pre-Tensioner circuit poor electrical connection
Faulty Air Bag Sensor Unit (Air Bag Control Module)
|How to Fix the B1183 INFINITI Code?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|What is the cost to diagnose the B1183 INFINITI code?
The cost to diagnose the B1183 INFINITI code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B1183 INFINITI code possible symptoms?
Air Bag Warning Light ON
|What Does the B1183 INFINITI Code Mean?
The Air Bag Sensor Unit (Air Bag Control Module) monitors the Left Front Seat Belt Buckle Pre-Tensioner. The Air Bag Sensor Unit sets the OBDII code when the circuit for the front Left Front Seat Belt Buckle Pre-Tensioner is shorted to some power supply circuit.
Left Front Seat Belt Buckle Pre-Tensioner Voltage Short
|Need more information with the B1183 INFINITI code?
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.