B1163 MERCURY - Left Power Running Board Hall-Effect Sensor Failure
B1163 MERCURY Possible Causes
- Faulty Power Running Board Motor Assembly
- Power Running Board Motor Assembly harness is open or shorted
- Power Running Board Motor Assembly circuit poor electrical connection
- Faulty Power Running Board (PRB) Module
How is the B1163 MERCURY code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the B1163 MERCURY code
Labor: 1.0The cost to diagnose the B1163 MERCURY code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
B1163 MERCURY MeaningThe Power Running Board (PRB) module provides a regulated 10-volt power supply to the Hall-effect sensor (internal to the PRB motor) through the circuit. The Hall-effect ground is provided by the PRB module through the circuit. The PRB module monitors the PRB Hall-effect signal through the circuit. If the PRB module does not receive any signal from the Hall-effect sensor during operation, the PRB will stop. The PRB module sets this Diagnostic Trouble Code (DTC) if it does not see any feedback from the Hall-Effect sensor during the stowing/deploying of the LH running board.
More InformationNeed more information on how to fix the B1163 MERCURY code?
Get Access to Factory Service Manuals