B115E MERCURY Code - Camera Module Bus Signal/Message Failure
|B115E MERCURY code possible causes
- Faulty Video Camera
- Video Camera harness is open or shorted
- Video Camera circuit poor electrical connection
|How is the B115E MERCURY code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|What is the cost to diagnose the B115E MERCURY code
Labor: 1.0The cost to diagnose the B115E MERCURY code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B115E MERCURY code possible symptoms?
- Anti-Lock Brake System (ABS) Warning Light ON
- Engine Light ON (or Service Engine Soon Warning Light)
|What is B115E MERCURY code meaning?When the ignition switch is in the RUN position, the video camera receives voltage. With the gear selector in reverse, the Accessory Protocol Interface Module (APIM) receives the reverse signal from the Body Control Module (BCM) over the Medium Speed Controller Area Network (MS-CAN), enabling the system. The video camera also receives the reverse signal message from BCM over the Local Interconnect Network (LIN). The LIN is a dedicated single wire communication line that sends and receives network messages from the BCM to the video camera. A pair of shielded wires carries the video signal from the video camera to the APIM . The APIM sends the video signal to the Front Display Interface Module (FDIM) and displays a video image of the area behind the vehicle. An on-demand DTC that sets in the BCM when there is a LIN communication fault from the video camera.
|Need more information with the B115E MERCURY code?Need more information on how to fix the B115E MERCURY code?
Get Access to Factory Service Manuals