Engine-Codes - Ford - B115E Ford

B115E Ford Code - Camera Module Bus Signal/Message Failure

- Code Popularity: 33,510 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B115E Ford?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Video Camera
  • Video Camera harness is open or shorted
  • Video Camera circuit poor electrical connection
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC B115E Ford?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B115E Ford Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B115E Ford code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Anti-Lock Brake System (ABS) Warning Light ON
  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the B115E Ford Code Mean?

When the ignition switch is in the RUN position, the video camera receives voltage. With the gear selector in reverse, the Accessory Protocol Interface Module (APIM) receives the reverse signal from the Body Control Module (BCM) over the Medium Speed Controller Area Network (MS-CAN), enabling the system. The video camera also receives the reverse signal message from BCM over the Local Interconnect Network (LIN). The LIN is a dedicated single wire communication line that sends and receives network messages from the BCM to the video camera. A pair of shielded wires carries the video signal from the video camera to the APIM . The APIM sends the video signal to the Front Display Interface Module (FDIM) and displays a video image of the area behind the vehicle. An on-demand DTC that sets in the BCM when there is a LIN communication fault from the video camera.

B115E Ford Code - Camera Module Bus Signal/Message Failure

Need more Information on the Code?

Need more information on how to fix the B115E Ford code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B115E Ford code diagnosed by a professional: Find a repair shop in your area