Engine-Codes - Lexus - B1157 Lexus

B1157 Lexus Code - Front Airbag Sensor RH Malfunction

- Code Popularity: 1,072 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B1157 Lexus?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Front Airbag Sensor (Right Side)
  • Front Airbag Sensor harness is open or shorted
  • Front Airbag Sensor circuit poor electrical connection
  • Faulty Airbag Sensor Assembly
⚠ Does your Lexus have Safety Recalls? → Check here

How to Fix the DTC B1157 Lexus?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B1157 Lexus Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B1157 Lexus code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Air Bag Warning Light ON

What Does the B1157 Lexus Code Mean?

The Front Airbag Sensor (Right Side) circuit consists of the Airbag Sensor Assembly and Front Airbag Sensor RH. The Diagnostic Trouble Code (DTC) B1157 is recorded when a malfunction is detected in the Front Airbag Sensor RH circuit.

B1157 Lexus Code - Front Airbag Sensor RH Malfunction

Need more Information on the Code?

Need more information on how to fix the B1157 Lexus code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B1157 Lexus code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.