|What are the Possible Causes of the B1150 SCION Code?
Faulty Occupant classification system
Faulty Airbag Sensor Assembly Center
Right front seat wire
|How to Fix the B1150 SCION Code?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|What is the cost to diagnose the B1150 SCION code?
The cost to diagnose the B1150 SCION code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the B1150 SCION code detected?
The B1150 code is recorder when a malfunction is detected in the occupant classification system.
|What are B1150 SCION code possible symptoms?
Airbag Warning Light ON
|What Does the B1150 SCION Code Mean?
The occupant classification system circuit consists of the Airbag Sensor Assembly Center and the occupant classification system. If the airbags sensor assy center receives signals from the occupant classification ECU, it determines whether or not the front passenger airbag assy and the front seat airbag assy sight should be operated.
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.