Engine-Codes - Toyota - B1142 Toyota

B1142 Toyota Code - Door Side Airbag Sensor Malfunction

- Code Popularity: 2,138 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

What are the Possible Causes of the Code B1142 Toyota?

  • Faulty Door Side Airbag Sensor (Right Side)
  • Door Side Airbag Sensor (Right Side) harness is open or shorted
  • Door Side Airbag Sensor (Right Side) circuit poor electrical connection
  • Faulty Airbag Sensor Assembly

How to Fix the B1142 Toyota Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

What is the Cost to Diagnose the Code B1142 Toyota?

Labor: 1.0

The cost to diagnose the B1142 Toyota code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your Toyota have Safety Recalls? → Check here

What are Code B1142 Toyota Possible Symptoms?

  • Air Bag Warning Light ON

What Does the B1142 Toyota Code Mean?

The Door Side Airbag Sensor (Right Side) circuit consists of the airbag sensor assembly and Door Side Airbag Sensor (Right Side). The Diagnostic Trouble Code (DTC) B1142 is recorded when a malfunction is detected in the Door Side Airbag Sensor (Right Side) circuit.

B1142 Toyota Code - Door Side Airbag Sensor Malfunction

Need more Information on the B1142 Toyota Code?

Need more information on how to fix the B1142 Toyota code? Get Access to Factory Service Manuals

Need Help with the B1142 Toyota Code?

Get the B1142 Toyota code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.