OBDII Code List

B1136 INFINITI - Left Right Side Air Bag Module Short

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

B1136 INFINITI Possible Causes

  • Faulty Left Right Side Air Bag Module
  • Left Right Side Air Bag Module harness is open or shorted
  • Left Right Side Air Bag Module circuit poor electrical connection

Cost of diagnosing the B1136 INFINITI code

    Labor: 1.0

    The cost of diagnosing the B1136 INFINITI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

B1136 INFINITI Possible Symptoms

  • Air Bag Warning Light ON

B1136 INFINITI Meaning

In case of collision whose acceleration exceeds the specified level, the ignition materials are ignited by the electric ignition system. The system burns and introduces the chemical reaction of gas generating materials to generate hot gases that flow into the air bag through a filter and expand the bag.

Front Left Side Air Bag Module mainly consists of air bag and inflator which inflates the air bag.

OBDII Code B1136 INFINITI - Left Right Side Air Bag Module Short - Engine-Codes.com

B1136 INFINITI More Information

Need more information on how to fix the B1136 INFINITI code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Related Information