Engine-Codes - Lexus - B1135 Lexus

B1135 Lexus Code - Half Connection In Airbag Sensor Assembly Center Connectors

- Code Popularity: 2,697 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code B1135 Lexus?

  • Faulty Airbag Sensor Assembly Center
  • Airbag Sensor Assembly Center harness is open or shorted
  • Airbag Sensor Assembly Center circuit poor electrical connection

|How to Fix the B1135 Lexus Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the Cost to Diagnose the Code B1135 Lexus?

Labor: 1.0

The cost to diagnose the B1135 Lexus code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your car have Safety Recalls? → Check here

|What are Code B1135 Lexus Possible Symptoms?

  • Air Bag Warning Light ON

|What Does the B1135 Lexus Code Mean?

The airbag sensor assy center detects partial connection of connector. DTC B1135 is recorded when the airbag sensor assy center detects an open in the electrical connection check mechanism of the airbag sensor connector or in the airbag sensor circuit.

Half Connection In Airbag Sensor Assembly Center Connectors

|Need more Information on the B1135 Lexus Code?

Need more information on how to fix the B1135 Lexus code? Get Access to Factory Service Manuals

|Need Help with the B1135 Lexus Code?

Get the B1135 Lexus code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.