Engine-Codes - Infiniti - B1120 Infiniti

B1120 Infiniti Code - Left Air Bag Satellite Sensor

- Code Popularity: 2,498 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B1120 Infiniti?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Left Air Bag Satellite Sensor
  • Left Air Bag Satellite Sensor harness is open or shorted
  • Left Air Bag Satellite Sensor circuit poor electrical connection
⚠ Does your Infiniti have Safety Recalls? → Check here

How to Fix the DTC B1120 Infiniti?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B1120 Infiniti Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B1120 Infiniti code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Air Bag Warning Light ON

What Does the B1120 Infiniti Code Mean?

When the Air Bag Diagnosis Sensor Unit (ACU) define the both signal voltage of the “G” sensor and the Safing sensor to be that of the collision which exceeds the specified level, the driving circuit switches on and feeds the electric ignitor of both the side air bag and curtain air bag.
The Satellite Sensor is an integrated type of the G sensor element for side collision with output terminals for signal voltage.

B1120 Infiniti Code - Left Air Bag Satellite Sensor

Need more Information on the Code?

Need more information on how to fix the B1120 Infiniti code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B1120 Infiniti code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.