B1117 MERCURY - Audio Steering Wheel Button Stuck
B1117 MERCURY Possible Causes
- Faulty Audio Steering Wheel Switch
- Audio Steering Wheel Switch harness is open or shorted
- Audio Steering Wheel Switch circuit poor electrical connection
How is the B1117 MERCURY code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the B1117 MERCURY code
Labor: 1.0The cost to diagnose the B1117 MERCURY code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
B1117 MERCURY MeaningTwo different steering wheel switch configurations are available, depending on whether the vehicle is equipped with the SYNC system.
On vehicles without the SYNC system, all of the steering wheel control switches are wired to the Audio Control Module (ACM). The steering wheel controls are: VOL+, VOL-, SEEK+, SEEK-, and MEDIA. The SEEK+ and SEEK- switches are represented by arrows.
For vehicles equipped with the SYNC system, the steering wheel controls are: VOL+, VOL-, SEEK+, SEEK-, MEDIA, VOICE, PHONE, and OK. The SEEK+ and SEEK- switches are represented by arrows, the VOICE button is represented by an icon of someone speaking, and the PHONE button is represented by an icon of a phone with an up-and-down arrow. The VOICE, PHONE, and OK switches are wired to the accessory protocol interface module (APIM), while the remaining switches are wired to the ACM.
For all switches, a reference voltage is sent from the appropriate module to the steering wheel controls. When a switch is pressed, the voltage is routed through a specific resistor value for each function. The module provides the ground for the reference voltage. The module uses this reference voltage to determine which control input function has been selected.
More InformationNeed more information on how to fix the B1117 MERCURY code?
Get Access to Factory Service Manuals