Engine-Codes - Generic - B1116

B1116 Code - Right Air Bag Satellite Sensor

- Code Popularity: 2,088 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the B1116 Code?

  • Faulty Right Air Bag Satellite Sensor
  • Right Air Bag Satellite Sensor harness is open or shorted
  • Right Air Bag Satellite Sensor circuit poor electrical connection

|How to Fix the B1116 Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the cost to diagnose the B1116 code?

Labor: 1.0

The cost to diagnose the B1116 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are B1116 code possible symptoms?

  • Air Bag Warning Light ON

|What Does the B1116 Code Mean?

When the Air Bag Diagnosis Sensor Unit (ACU) define the both signal voltage of the “G” sensor and the Safing sensor to be that of the collision which exceeds the specified level, the driving circuit switches on and feeds the electric ignitor of both the side air bag and curtain air bag.
The Satellite Sensor is an integrated type of the G sensor element for side collision with output terminals for signal voltage.

Right Air Bag Satellite Sensor

|Need more information with the B1116 code?

Need more information on how to fix the B1116 code?
Get Access to Factory Service Manuals

|B1116 code information for specific makes

|Need help with a B1116 code?

Get the b1116 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.