OBDII Code List

B1113 INFINITI - Right Air Bag Satellite Sensor

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

B1113 INFINITI Possible Causes

  • Faulty Right Air Bag Satellite Sensor
  • Right Air Bag Satellite Sensor harness is open or shorted
  • Right Air Bag Satellite Sensor circuit poor electrical connection

How do I fix code B1113 INFINITI

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Cost of diagnosing the B1113 INFINITI code

    Labor: 1.0

    The cost of diagnosing the B1113 INFINITI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

B1113 INFINITI Possible Symptoms

  • Air Bag Warning Light ON

B1113 INFINITI Meaning

When the Air Bag Diagnosis Sensor Unit (ACU) define the both signal voltage of the “G” sensor and the Safing sensor to be that of the collision which exceeds the specified level, the driving circuit switches on and feeds the electric ignitor of both the side air bag and curtain air bag.
The Satellite Sensor is an integrated type of the G sensor element for side collision with output terminals for signal voltage.
OBDII Code B1113 INFINITI - Right Air Bag Satellite Sensor - Engine-Codes.com

B1113 INFINITI More Information

Need more information on how to fix the B1113 INFINITI code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Related Information