Engine-Codes - Generic - B10E7

B10E7 Code - Ignition On Relay

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What is this?
Table of contents

|B10E7 code possible causes

  • Faulty Ignition On Relay
  • Ignition On Relay harness is open or shorted
  • Ignition On Relay circuit poor electrical connection
  • Faulty Body Control Module (BCM)

|How is the B10E7 code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|B10E7 code tech notes

B10E7:12 Ignition On Relay Short To Battery
B10E7:14 Ignition On Relay Circuit Short To Ground or Open

|What is the cost to diagnose the B10E7 code

Labor: 1.0

The cost to diagnose the B10E7 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are B10E7 code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What is B10E7 code meaning?

Conventional Ignition Switch:
The ignition switch is a multiple position rotary switch that is controlled by a lock cylinder and a key. The ignition switch provides voltage to the ACC, ON, or START-designated circuits depending on the position it is placed. The Body Control Module (BCM) calculates the positions based on the voltage received from the ACC and ON-designated circuits.
The key removal inhibit solenoid (also known as the key release interlock actuator) is an electronically controlled solenoid that prevents the ignition lock cylinder from being turned to the OFF position unless the gear selector lever is in the PARK position. The key removal inhibit solenoid is part of the ignition switch.

Push Button Ignition Switch:
The push button ignition switch is used instead of a conventional ignition switch to achieve the various ignition modes. The push button ignition switch is a momentary dual contact switch. Both sets of contacts are normally open and receive the voltage at all times. When the START/STOP button is pressed, the voltage is sent to the BCM, the RFA module, and the PCM to indicate a button press.
The ignition switch has a LED for switch illumination when the backlighting is activated.

|Need more information with the B10E7 code?

Need more information on how to fix the B10E7 code?
Get Access to Factory Service Manuals

|B10E7 code information for specific makes

|Need help with a B10E7 code?

Get the B10e7 code diagnosed by a professional: Find a repair shop in your area