Engine-Codes
 
OBDII Code List
 
B10A2 LINCOLN

B10A2 LINCOLN - Crash Input General Failure Information General Signal Failure

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

B10A2 LINCOLN Possible Causes

  • Faulty Restraints Control Module (RCM)
  • Restraints Control Module (RCM) harness is open or shorted
  • Restraints Control Module (RCM) circuit poor electrical connection
  • Faulty Body Control Module (BCM)

First diagnose B10A2 LINCOLN code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

Cost of diagnosing the B10A2 LINCOLN code

    Labor: 1.0

    The cost of diagnosing the B10A2 LINCOLN code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

B10A2 LINCOLN Possible Symptoms

  • Air Bag Warning Light ON

B10A2 LINCOLN Meaning

The Body Control Module (BCM) monitors the Restraints Control Module (RCM). The BCM sets the OBDII code when the Restraints Control Module (RCM) is not to factory specifications.
OBDII Code B10A2 LINCOLN - Crash Input General Failure Information General Signal Failure - Engine-Codes.com

B10A2 LINCOLN More Information

Need more information on how to fix the B10A2 LINCOLN code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Related Information