Engine-Codes - Mercury - B108C Mercury

B108C Mercury Code - Start Button Circuit 'B'

- Code Popularity: 649 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B108C Mercury?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Start Button Switch
  • Start Button Switch harness is open or shorted
  • Start Button Switch circuit poor electrical connection
  • Faulty Body Control Module (BCM)

Code Tech Notes

B108C:23 Start Button Circuit 'B' Signal Stuck Low
B108C:24 Start Button Circuit 'B' Signal Stuck High
B108C:2F Start Button Circuit 'B' Signal Erratic

⚠ Does your Mercury have Safety Recalls? → Check here

How to Fix the DTC B108C Mercury?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B108C Mercury Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B108C Mercury code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the B108C Mercury Code Mean?

Conventional Ignition Switch:
The ignition switch is a multiple position rotary switch that is controlled by a lock cylinder and a key. The ignition switch provides voltage to the ACC, ON, or START-designated circuits depending on the position it is placed. The Body Control Module (BCM) calculates the positions based on the voltage received from the ACC and ON-designated circuits.
The key removal inhibit solenoid (also known as the key release interlock actuator) is an electronically controlled solenoid that prevents the ignition lock cylinder from being turned to the OFF position unless the gear selector lever is in the PARK position. The key removal inhibit solenoid is part of the ignition switch.

Push Button Ignition Switch:
The push button ignition switch is used instead of a conventional ignition switch to achieve the various ignition modes. The push button ignition switch is a momentary dual contact switch. Both sets of contacts are normally open and receive the voltage at all times. When the START/STOP button is pressed, the voltage is sent to the BCM, the RFA module, and the PCM to indicate a button press.
The ignition switch has a LED for switch illumination when the backlighting is activated.

B108C Mercury Code - Start Button Circuit 'B'

Need more Information on the Code?

Need more information on how to fix the B108C Mercury code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B108C Mercury code diagnosed by a professional: Find a repair shop in your area