B108C LINCOLN Code - Start Button Circuit 'B'
|B108C LINCOLN code possible causes
- Faulty Start Button Switch
- Start Button Switch harness is open or shorted
- Start Button Switch circuit poor electrical connection
- Faulty Body Control Module (BCM)
|How is the B108C LINCOLN code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|B108C LINCOLN code tech notesB108C:23 Start Button Circuit 'B' Signal Stuck Low
B108C:24 Start Button Circuit 'B' Signal Stuck High
B108C:2F Start Button Circuit 'B' Signal Erratic
|What is the cost to diagnose the B108C LINCOLN code
Labor: 1.0The cost to diagnose the B108C LINCOLN code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B108C LINCOLN code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|What is B108C LINCOLN code meaning?Conventional Ignition Switch:
The ignition switch is a multiple position rotary switch that is controlled by a lock cylinder and a key. The ignition switch provides voltage to the ACC, ON, or START-designated circuits depending on the position it is placed. The Body Control Module (BCM) calculates the positions based on the voltage received from the ACC and ON-designated circuits.
The key removal inhibit solenoid (also known as the key release interlock actuator) is an electronically controlled solenoid that prevents the ignition lock cylinder from being turned to the OFF position unless the gear selector lever is in the PARK position. The key removal inhibit solenoid is part of the ignition switch.
Push Button Ignition Switch:
The push button ignition switch is used instead of a conventional ignition switch to achieve the various ignition modes. The push button ignition switch is a momentary dual contact switch. Both sets of contacts are normally open and receive the voltage at all times. When the START/STOP button is pressed, the voltage is sent to the BCM, the RFA module, and the PCM to indicate a button press.
The ignition switch has a LED for switch illumination when the backlighting is activated.
|Need more information with the B108C LINCOLN code?Need more information on how to fix the B108C LINCOLN code?
Get Access to Factory Service Manuals