B1081 LINCOLN Code - Temperature Damper Motor Circuit
|B1081 LINCOLN code possible causes
- Faulty Temperature Damper Motor
- Temperature Damper Motor harness is open or shorted
- Temperature Damper Motor circuit poor electrical connection
- Faulty Heating, Ventilation, and Air Conditioning (HVAC) Module
|How is the B1081 LINCOLN code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|B1081 LINCOLN code tech notesB1081:11 - Left Temperature Damper Motor: Circuit Short to Ground
B1081:12 - Left Temperature Damper Motor: Circuit Short to Battery
B1081:13 - Left Temperature Damper Motor: Circuit Open
|What is the cost to diagnose the B1081 LINCOLN code
Labor: 1.0The cost to diagnose the B1081 LINCOLN code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B1081 LINCOLN code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|What is B1081 LINCOLN code meaning?o rotate the temperature blend door actuator, the Heating, Ventilation, and Air Conditioning (HVAC) module supplies voltage and ground to the temperature blend door actuator through the door actuator motor circuits. To reverse the temperature blend door actuator rotation, the HVAC module reverses the voltage and ground circuits.
The temperature blend door actuator feedback resistors are supplied a ground from the HVAC module by the temperature blend door actuator return circuits and a 5-volt reference voltage on the temperature blend door actuator reference circuits. The HVAC module reads the voltage on the temperature blend door actuator feedback circuits to determine the temperature blend door actuator position by the position of the actuator feedback resistor wiper arm.
During an actuator calibration cycle, the HVAC module drives the temperature blend door until the door reaches both internal stops in the HVAC case. If the temperature blend door is temporarily obstructed or binding during a calibration cycle, the HVAC module may interpret this as the actual end of travel for the door. When this condition occurs and the HVAC module commands the actuator to its end of travel, the airflow may not be the expected temperature.
|Need more information with the B1081 LINCOLN code?Need more information on how to fix the B1081 LINCOLN code?
Get Access to Factory Service Manuals