B1068 INFINITI Code - Assist Air Bag Module Short
|B1068 INFINITI code possible causes
- Faulty Assist Air Bag Module
- Assist Air Bag Module harness is open or shorted
- Assist Air Bag Module circuit poor electrical connection
- Faulty Diagnosis Sensor Unit
|How is the B1068 INFINITI code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|What is the cost to diagnose the B1068 INFINITI code
Labor: 1.0The cost to diagnose the B1068 INFINITI code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B1068 INFINITI code possible symptoms?
- Air Bag Warning Light ON
|What is B1068 INFINITI code meaning?In the case of a frontal collision whose acceleration exceeds the specified level, the ignition materials are ignited by the electric ignition system. The system burns and introduces the chemical reaction of gas generating materials to generate hot gases that flow into the air bag through a filter and expand the bag.
The front passenger air bag module mainly consists of air bag and inflator which inflates the air bag.
|Need more information with the B1068 INFINITI code?Need more information on how to fix the B1068 INFINITI code?
Get Access to Factory Service Manuals
|Need help with a B1068 INFINITI code?Get the B1068 Infiniti code diagnosed by a professional: Find a repair shop in your area
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.