Engine-Codes - Infiniti - B1023 Infiniti

B1023 Infiniti Code - Passenger A/B Indicator

- Code Popularity: 4,708 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code B1023 Infiniti?

  • Faulty Passenger A/B Indicator
  • Passenger A/B Indicator harness is open or shorted
  • Passenger A/B Indicator circuit poor electrical connection
  • Faulty Diagnosis Sensor Unit

|How to Fix the B1023 Infiniti Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the Cost to Diagnose the Code B1023 Infiniti?

Labor: 1.0

The cost to diagnose the B1023 Infiniti code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your car have Safety Recalls? → Check here

|What are Code B1023 Infiniti Possible Symptoms?

  • Air Bag Warning Light ON

|What Does the B1023 Infiniti Code Mean?

The Passenger A/B Indicator Suppresses the deployment of passenger air bag when the condition of the passenger seat is empty or child and child-seat. And turns on the passenger air bag indicator (cut-off telltale) lamp when the condition of passenger seat is child-seat and child. In case of malfunction, the blinking of the SRS air bag warning lamp reports the malfunction to the driver and by the on board self-diagnosis system.
The Passenger A/B Indicator turns on passenger air bag indicator (cut-off telltale) when the passenger seat is empty or occupied by childseat and child.

Passenger A/B Indicator

|Need more Information on the B1023 Infiniti Code?

Need more information on how to fix the B1023 Infiniti code? Get Access to Factory Service Manuals

|Need Help with the B1023 Infiniti Code?

Get the B1023 Infiniti code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.