B1007 FORD - High-Beam Headlamp Switch Component Failure
B1007 FORD Possible Causes
- Faulty High-Beam Headlamp Switch
- High-Beam Headlamp Switch harness is open or shorted
- High-Beam Headlamp Switch circuit poor electrical connection
- Faulty Steering Column Control Module (SCCM)
How is the B1007 FORD code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the B1007 FORD code
Labor: 1.0The cost to diagnose the B1007 FORD code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
B1007 FORD MeaningThe Steering Column Control Module (SCCM) monitors input from the multifunction and headlamp switches. When the headlamp switch is in the HEADLAMPS ON position and the multifunction switch is placed in the HIGH BEAM position, the SCCM sends a message to the Body Control Module (BCM) over the High Speed Controller Area Network (HS-CAN), indicating a high beam request. The BCM then provides voltage to the high beams. The BCM provides an overload protection of the high beam output circuits. When an excessive current draw is detected, the BCM disables the affected high beam circuit driver. The Instrument Panel Cluster (IPC) also receives a message over the HS-CAN to illuminate the high beam indicator when a request for the high beams is received. This DTC sets when the SCCM detects a fault from the multifunction switch input.
More InformationNeed more information on how to fix the B1007 FORD code?
Get Access to Factory Service Manuals