B1000 DODGE - A/C Switch Request Input Performance Or Incorrect Operation
B1000 DODGE Possible Causes
- Faulty A/C Switch
- A/C Switch harness is open or shorted
- A/C Switch circuit poor electrical connection
- Faulty A/C Heater Control
How is the B1000 DODGE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the B1000 DODGE code
Labor: 1.0The cost to diagnose the B1000 DODGE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
- Engine Light ON (or Service Engine Soon Warning Light)
B1000 DODGE MeaningThe HVAC A/C Heater Control contains various switches and knobs that are used to change the systems operation. There are currently three types of switches used depending on the configuration of the system. Push button momentary switches which are normally open or in the Off position. Multifunction or rotary switches which have several distinct positions and potentiometers which are a rotary variable resistor that is used for a more precise control. An active Diagnostic Trouble Code (DTC) indicates that either a control switch or potentiometer is stuck in an On position or out of a calibrated range. A stored DTC indicates that control switch or potentiometer was stuck On or out of calibration but has since returned to its normal state.
More InformationNeed more information on how to fix the B1000 DODGE code?
Get Access to Factory Service Manuals