B0958 CADILLAC - Parking Aid Rear Sensor 1 Left Corner Circuit
B0958 CADILLAC Possible Causes
- Faulty Parking Aid Rear Sensor 1 Left Corner
- Parking Aid Rear Sensor 1 Left Corner harness is open or shorted
- Parking Aid Rear Sensor 1 Left Corner circuit poor electrical connection
How do I fix code B0958 CADILLAC
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
B0958 CADILLAC Tech NotesB0958 01 Parking Aid Rear Sensor 1 Left Corner Circuit Short to Battery
B0958 06 Parking Aid Rear Sensor 1 Left Corner Circuit Short to Ground or Open
B0958 08 Parking Aid Rear Sensor 1 Left Corner Circuit Signal Invalid
B0958 21 Parking Aid Rear Sensor 1 Left Corner Circuit Incorrect Period
Cost of diagnosing the B0958 CADILLAC code
Labor: 1.0The cost of diagnosing the B0958 CADILLAC code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
B0958 CADILLAC Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B0958 CADILLAC MeaningThe object alarm detection system senses how close the vehicle is to an object. The distance is determined by the 4 ultrasonic sensors located in the rear bumper. The object detection system will notify the driver when backing up at speeds less than 8 km/h (5 mph), which make parking easier and helps you avoid colliding with objects such as parked vehicles. Each object sensor is a 3-wire sensor that is both a transmitter and a receiver that comprises a signal circuit, a low reference circuit, and an 8-volt supply voltage circuit. The rear object control module supplies 8 volts to the object sensors via the object sensor supply voltage circuit and provides ground via the low reference circuit. The rear object control module triggers the sensors in a sequential loop and after each sensor transmits, the rear object control module uses the echo or signal return to calculate the distance and position of an object from the rear bumper. The rear object control module directly controls the Rear Parking Assist (RPA) display. The RPA consists of 2 amber and one red LED that indicates the range of an object from the rear bumper. The rear object control module will also use an audible warning by sending a low speed GMLAN message to the radio.
B0958 CADILLAC More InformationNeed more information on how to fix the B0958 CADILLAC code?
Get Access to Factory Service Manuals