Engine-Codes - GMC - B0680 GMC

B0680 GMC Code - Passenger Air Bag Off Indicator Circuit

- Code Popularity: 957 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B0680 GMC?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Passenger Air Bag Disable Indicator
  • Passenger Air Bag Disable Indicator harness is open or shorted
  • Passenger Air Bag Disable Indicator circuit poor electrical connection
  • Faulty Inflatable Restraint Sensing and Diagnostic Module (SDM)

Code Tech Notes

B0680:01 Passenger Air Bag Off Indicator Circuit Short to Battery
B0680:02 Passenger Air Bag Off Indicator Circuit Short to Ground
B0680:04 Passenger Air Bag Off Indicator Circuit Open
B0680:05 Passenger Air Bag Off Indicator Circuit High Voltage/Open

⚠ Does your GMC have Safety Recalls? → Check here

How to Fix the DTC B0680 GMC?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B0680 GMC Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B0680 GMC code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Air Bag Warning Light ON

What Does the B0680 GMC Code Mean?

The passenger air bag ON/OFF indicators are used to notify the driver when the passenger presence system has enabled or disabled the passenger instrument panel air bag. When the Inflatable Restraint Sensing and Diagnostic Module (SDM) receives the appropriate serial data message from the passenger presence module (if equipped) the inflatable restraint sensing and diagnostic module will then provide voltage to the appropriate indicator. When air bag disable switch (if equipped) has been switched to either OFF or ON, the corresponding air bag indicator will be illuminated by the inflatable restraint sensing and diagnostic module. The Diagnostic Trouble Code (DTC) will be set when the Inflatable Restraint Sensing and Diagnostic Module detects improper voltage on the control circuit of the indicator.

B0680 GMC Code - Passenger Air Bag Off Indicator Circuit

Need more Information on the Code?

Need more information on how to fix the B0680 GMC code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B0680 GMC code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.