Engine-Codes
 
OBDII Code List
 
B0680 CADILLAC

B0680 CADILLAC - Passenger Air Bag Off Indicator Circuit

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

B0680 CADILLAC Possible Causes

  • Faulty Passenger Air Bag Disable Indicator
  • Passenger Air Bag Disable Indicator harness is open or shorted
  • Passenger Air Bag Disable Indicator circuit poor electrical connection
  • Faulty Inflatable Restraint Sensing and Diagnostic Module (SDM)

B0680 CADILLAC Tech Notes

B0680 01: Passenger Air Bag Off Indicator Circuit Short to Battery
B0680 02: Passenger Air Bag Off Indicator Circuit Short to Ground
B0680 04: Passenger Air Bag Off Indicator Circuit Open

Cost of diagnosing the B0680 CADILLAC code

    Labor: 1.0

    The cost of diagnosing the B0680 CADILLAC code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

B0680 CADILLAC Possible Symptoms

  • Air Bag Warning Light ON

B0680 CADILLAC Meaning

The passenger air bag ON/OFF indicators are used to notify the driver when the passenger presence system has enabled or disabled the passenger instrument panel air bag. When the ignition is turned ON, the ignition voltage is supplied to the passenger presence module. When the Inflatable Restraint Sensing and Diagnostic Module (SDM) receives the appropriate serial data message from the passenger presence module the SDM will then provide voltage to the appropriate indicator.
OBDII Code B0680 CADILLAC - Passenger Air Bag Off Indicator Circuit - Engine-Codes.com

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Related Information