Engine-Codes - Gmc - B067F GMC

B067F GMC Code - Passenger Air Bag On Indicator Circuit

- Code Popularity: 917 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code B067F GMC?

  • Faulty Passenger Air Bag Disable Indicator
  • Passenger Air Bag Disable Indicator harness is open or shorted
  • Passenger Air Bag Disable Indicator circuit poor electrical connection
  • Faulty Inflatable Restraint Sensing and Diagnostic Module (SDM)

|How to Fix the B067F GMC Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Code B067F GMC Tech Notes

B067F:01 Passenger Air Bag On Indicator Circuit Short to Battery
B067F:02 Passenger Air Bag On Indicator Circuit Short to Ground
B067F:04 Passenger Air Bag On Indicator Circuit Open
B067F:05 Passenger Air Bag On Indicator Circuit High Voltage/Open

|What is the Cost to Diagnose the Code B067F GMC?

Labor: 1.0

The cost to diagnose the B067F GMC code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your car have Safety Recalls? → Check here

|What are Code B067F GMC Possible Symptoms?

  • Air Bag Warning Light ON

|What Does the B067F GMC Code Mean?

The passenger air bag ON/OFF indicators are used to notify the driver when the passenger presence system has enabled or disabled the passenger instrument panel air bag. When the Inflatable Restraint Sensing and Diagnostic Module (SDM) receives the appropriate serial data message from the passenger presence module (if equipped) the inflatable restraint sensing and diagnostic module will then provide voltage to the appropriate indicator. When air bag disable switch (if equipped) has been switched to either OFF or ON, the corresponding air bag indicator will be illuminated by the inflatable restraint sensing and diagnostic module. The Diagnostic Trouble Code (DTC) will be set when the Inflatable Restraint Sensing and Diagnostic Module detects improper voltage on the control circuit of the indicator.

Passenger Air Bag On Indicator Circuit

|Need more Information on the B067F GMC Code?

Need more information on how to fix the B067F GMC code? Get Access to Factory Service Manuals

|Need Help with the B067F GMC Code?

Get the B067F GMC code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.