Engine-Codes - Buick - B0417 Buick

B0417 Buick Code - Temperature Control Left Feedback Circuit Actuator Open

- Code Popularity: 538 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B0417 Buick?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Left Air Temperature Actuator
  • Left Air Temperature Actuator harness is open or shorted
  • Left Air Temperature Actuator circuit poor electrical connection
  • Faulty Heating, Ventilation, and Air Conditioning (HVAC) Control Module
⚠ Does your Buick have Safety Recalls? → Check here

How to Fix the DTC B0417 Buick?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B0417 Buick Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B0417 Buick code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the B0417 Buick Code Mean?

The Heating, Ventilation, and Air Conditioning (HVAC) Control Module controls the HVAC door actuators to regulate the airflow through the HVAC system. Each actuator consists of a stepper motor, a logic circuit, and a potentiometer. The potentiometer inside the door actuator allows the module to monitor the current position of the actuator drive shaft. The module supplies a 5-volt source voltage to the potentiometer on the 5-volt reference circuit. The module supplies ground to the potentiometer through the low reference circuit. The HVAC control module monitors the voltage drop across the potentiometer on the door position signal circuit. When the actuator shaft rotates, the voltage on the door position signal circuit changes. The module converts the voltage value to a count value where 1-volt is approximately equal to 51 counts. The HVAC control module calibrates the travel range of the HVAC door actuators when it is initially powered by the battery positive voltage circuit. During calibration, the module commands the actuators in each direction until door travel is stopped. The module stores the minimum door positions and the maximum door positions of each actuator into memory. The total travel range is calculated by subtracting the minimum door position from the maximum door position.

B0417 Buick Code - Temperature Control Left Feedback Circuit Actuator Open

Need more Information on the Code?

Need more information on how to fix the B0417 Buick code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B0417 Buick code diagnosed by a professional: Find a repair shop in your area