Engine-Codes - Chevrolet - B0228 CHEVROLET

B0228 CHEVROLET Code - Recirculate Position Feedback Circuit

- Code Popularity: 15,701 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 2/3
Table of contents

|What are the Possible Causes of the B0228 CHEVROLET Code?

  • Faulty Recirculate Actuator
  • Recirculate Actuator harness is open or shorted
  • Recirculate Actuator circuit poor electrical connection

|How to Fix the B0228 CHEVROLET Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|B0228 CHEVROLET code tech notes

DTC B0228 02 - Recirculate Position Feedback Circuit Short to Ground
DTC B0228 05 - Recirculate Position Feedback Circuit Short to Battery or Open
DTC B0228 61 - Recirculate Position Circuit Actuator Stuck

|What is the cost to diagnose the B0228 CHEVROLET code?

Labor: 1.0

The cost to diagnose the B0228 CHEVROLET code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are B0228 CHEVROLET code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the B0228 CHEVROLET Code Mean?

The Heating, Ventilation, and Air Conditioning (HVAC) control module controls the HVAC door actuators to regulate the airflow through the HVAC system. Each actuator consists of an electric motor and a potentiometer. The module supplies a low reference and 5-volt reference source voltage to the potentiometer. The HVAC control module monitors the voltage drop across the potentiometer on the door position signal circuit. When the actuator shaft rotates, the voltage on the door position signal circuit changes. The control circuit uses either a 0, 2.5 or 5-volt signal to command the actuator movement. When the actuator is at rest, the control circuit value is 2.5 volts. A 0 or 5-volt control signal commands the actuator movement in opposite directions.

Recirculate Position Feedback Circuit

|Need more information with the B0228 CHEVROLET code?

Need more information on how to fix the B0228 CHEVROLET code?
Get Access to Factory Service Manuals

|Need help with a B0228 CHEVROLET code?

Get the B0228 Chevrolet code diagnosed by a professional: Find a repair shop in your area