Engine-Codes - Hummer - B0150 Hummer

B0150 Hummer Code - Air Flow Position Feedback #3 Circuit Malfunction

- Code Popularity: 1,934 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC B0150 Hummer?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Auxiliary Mode Actuator
  • Auxiliary Mode Actuator harness is open or shorted
  • Auxiliary Mode Actuator circuit poor electrical connection
  • Faulty Auxiliary Heating, Ventilation, and Air Conditioning (HVAC) Control Module
⚠ Does your Hummer have Safety Recalls? → Check here

How to Fix the DTC B0150 Hummer?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for B0150 Hummer Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the B0150 Hummer code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the B0150 Hummer Code Mean?

The actuators operate using 5 circuits. A 5-volt reference, low reference, signal circuit and two bi-directional 0 or 12 volt control circuits. The Heating, Ventilation, and Air Conditioning (HVAC) Control Module supplies a low reference and 5-volt reference to the potentiometer. The HVAC control module monitors the voltage drop across the potentiometer on the door position signal circuit. As the actuator door changes position the door position signal circuit voltage also changes. The two bi-directional control circuits enable the actuator to operate. Both circuits are set to 0 volts when the HVAC control module detects, from the feedback potentiometer, that the actuator is in the desired position. In order to move the actuator, the HVAC control module switches the appropriate control circuit to 12 volts.

B0150 Hummer Code - Air Flow Position Feedback #3 Circuit Malfunction

Need more Information on the Code?

Need more information on how to fix the B0150 Hummer code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B0150 Hummer code diagnosed by a professional: Find a repair shop in your area