Engine-Codes -
Scion -
B0115 SCION
B0115 SCION - Short In Left-Side Air Bag Module Squib Circuit
Table of contents
B0115 SCION Possible Causes
- Faulty Left-Side Air Bag Module
- Left-Side Air Bag Module harness is open or shorted
- Left-Side Air Bag Module circuit poor electrical connection
- Faulty Air Bag Control Module
How is the B0115 SCION code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.What is the cost to diagnose the B0115 SCION code
Labor: 1.0
The cost to diagnose the B0115 SCION code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Possible Symptoms
- Air Bag Warning Light ON
B0115 SCION Meaning
The side air bag module squib circuit consists of the air bag sensor assembly and side air bag module. The squib circuit causes the side air bag to deploy when deployment conditions are satisfied. The Air Bag Control Module monitors the Left-Side Air Bag Module. The Air Bag Control Module sets the OBDII code when the Left-Side Air Bag Module is not to factory specifications.More Information
Need more information on how to fix the B0115 SCION code?Get Access to Factory Service Manuals
Need more help?
Get the B0115 Scion code diagnosed by a professional: Find a repair shop in your areaPrecautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.