Engine-Codes - Generic - B0111

B0111 Code - Open In Right-Side Air Bag Module Squib Circuit

- Code Popularity: 760 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code B0111?

  • Faulty Right-Side Air Bag Module
  • Right-Side Air Bag Module harness is open or shorted
  • Right-Side Air Bag Module circuit poor electrical connection
  • Faulty Air Bag Control Module

|How to Fix the B0111 Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the Cost to Diagnose the Code B0111?

Labor: 1.0

The cost to diagnose the B0111 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your car have Safety Recalls? → Check here

|What are Code B0111 Possible Symptoms?

  • Air Bag Warning Light ON

|What Does the B0111 Code Mean?

The side air bag module squib circuit consists of the air bag sensor assembly and side air bag module. The squib circuit causes the side air bag to deploy when deployment conditions are satisfied. The Air Bag Control Module monitors the Right-Side Air Bag Module. The Air Bag Control Module sets the OBDII code when the Right-Side Air Bag Module is not to factory specifications.

Open In Right-Side Air Bag Module Squib Circuit

|Need more Information on the B0111 Code?

Need more information on how to fix the B0111 code? Get Access to Factory Service Manuals

|Code B0111 Information for Specific Makes

  • B0111 Lexus Open In Right-Side Air Bag Module Squib Circuit
  • B0111 Scion Open In Right-Side Air Bag Module Squib Circuit
  • B0111 Toyota Open In Right-Side Air Bag Module Squib Circuit

|Need Help with the B0111 Code?

Get the B0111 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.